tilting furnace hydraulic cylinder Sold to The Philippines

This article mainly introduces:

The Philippines hydraulic cylinder,tilting furnace hydraulic cylinder manufacturer,tilting furnace hydraulic cylinder

(The Philippines tilting furnace hydraulic cylinder,produced by Hengyu Hydraulic Co., Ltd）

tilting furnace hydraulic cylinder are widely used in The Philippines，because of smooth movement，high work efficiency，excellent fatigue and impact resistance.So our company has designed tilting furnace hydraulic cylinder for customers from The Philippines.

Introduction to tilting furnace hydraulic cylinder:

When the piston speed of the tilting furnace hydraulic cylinder is high, the steel ball of the check valve flows with the oil flow, so that the valve hole is blocked, and the tilting furnace hydraulic cylinder moves irregularly. Elimination method: Replace the steel ball with a cone valve or spool with a guide shoulder.

The material, shape and compression of the tilting furnace hydraulic cylinder seal have a great impact on the service life and work efficiency of the tilting furnace hydraulic cylinder. In addition to requiring a reliable seal, it should also have a long service life and less friction loss. At present, there are many seal manufacturers in the country, and it is also crucial to choose high-quality seals with reliable and stable quality.

At the rated pressure, the thrust of the tilting furnace hydraulic cylinder is determined by what factors: at the rated pressure of the oil pump, the work done by the tilting furnace hydraulic cylinder is related to the diameter of the tilting furnace hydraulic cylinder, but not to the stroke of the tilting furnace hydraulic cylinder. Moreover, the larger the tilting furnace hydraulic cylinder diameter, the larger the area, and the greater the pressure obtained. To this point, we should have a correct understanding and clear understanding, so as to avoid problems in the use of the tilting furnace hydraulic cylinder.

When the tilting furnace hydraulic cylinder needs to be stored for a period of time, please follow the recommended methods: The tilting furnace hydraulic cylinder should be stored in a dry, clean, non-corrosive gas indoor environment, pay attention to protect the tilting furnace hydraulic cylinder from internal corrosion and external damage. If the indoor requirements cannot be met, the hardened and well-drained ground should be cushioned at least 30cm, and the upper part should be covered with waterproof storage. The oil tilting furnace hydraulic cylinder should not be in direct contact with water vapor for a long time. The tilting furnace hydraulic cylinder should be placed as vertically as possible with the piston rod facing up, which minimizes corrosion due to possible condensation in the tilting furnace hydraulic cylinder and permanent deformation of the seal due to the piston and rod weight. (When the shield is stored in the shield machine, the support shoe is placed upward). Keep the oil port protective cover until the pipe is connected. For long-term storage, the protection should be added on both sides of the piston of the tilting furnace hydraulic cylinder Before working, the tilting furnace hydraulic cylinder must be run repeatedly with low pressure (greater than the starting pressure) to discharge the air in the tilting furnace hydraulic cylinder before normal work. The oil inlet and outlet and the joint must be tightly fastened with a combination pad to prevent oil leakage.

Answers to some questions about tilting furnace hydraulic cylinder:

How to set up the one-way cylinder hydraulic system?
Single acting oil cylinder, that is, an oil cylinder with an oil port, can use two three-way valves to control the cylinder action. The three oil ports are respectively connected to P (oil pump), A (oil cylinder), and T (oil tank). If the oil pump is to run continuously, an electromagnetic relief valve can be added. When the cylinder is not moving, the relief valve can unload the oil pump. You can also add a three-way four-way valve, the middle function is unloaded, two outlets: A connected to the fuel tank, B connected to the cylinder.

How to refuel pneumatic riveting cylinder?
First put the gun flat, that is, horizontally, while pushing the stroke positioning pin and loosen the back cover, rotate to the left for a maximum of five turns, and then use a wrench to loosen the oil sealing screw, slowly add the hydraulic oil and let the air out, fill up to tighten the oil sealing screw. This process of adding hydraulic oil is over.