trunnion cylinder Sold to Slovakia

This article mainly introduces:

Slovakia hydraulic cylinder,trunnion cylinder manufacturer,trunnion cylinder

(Slovakia trunnion cylinder,produced by Hengyu Hydraulic Co., Ltd）

trunnion cylinder are widely used in Slovakia，because of excellent fatigue and impact resistance，no need for deceleration device，long service life.So our company has designed trunnion cylinder for customers from Slovakia.

Introduction to trunnion cylinder:

When the trunnion cylinder needs to be stored for a period of time, please follow the recommended methods: The trunnion cylinder should be stored in a dry, clean, non-corrosive gas indoor environment, pay attention to protect the trunnion cylinder from internal corrosion and external damage. If the indoor requirements cannot be met, the hardened and well-drained ground should be cushioned at least 30cm, and the upper part should be covered with waterproof storage. The oil trunnion cylinder should not be in direct contact with water vapor for a long time. The trunnion cylinder should be placed as vertically as possible with the piston rod facing up, which minimizes corrosion due to possible condensation in the trunnion cylinder and permanent deformation of the seal due to the piston and rod weight. (When the shield is stored in the shield machine, the support shoe is placed upward). Keep the oil port protective cover until the pipe is connected. For long-term storage, the protection should be added on both sides of the piston of the trunnion cylinder Before working, the trunnion cylinder must be run repeatedly with low pressure (greater than the starting pressure) to discharge the air in the trunnion cylinder before normal work. The oil inlet and outlet and the joint must be tightly fastened with a combination pad to prevent oil leakage.

The definition of the minimum stable speed refers to the minimum movement speed of the trunnion cylinder without crawling phenomenon when the full load is moving, it has no uniform indicator, and the trunnion cylinder that undertakes different work has different requirements for the minimum stable speed.

The pressure, temperature, medium and speed of different types of seals are not the same, water-ethylene glycol medium (HFC) can not be sealed with polyurethane, it can only use rubber seal; When the trunnion cylinder is running fast, it must be sealed with slip ring, such as Sterseal, Glairing, GD1000K, TDI, etc., when the running speed is slow, Yx, U, V combination seals can be used; Fluorine rubber seal is used in high temperature and high pressure environment; When the running speed is fast, the buffer sleeve and buffer valve must be considered.

If it is found that the trunnion cylinder lubrication is poor or the trunnion cylinder bore processing is abnormal, it is necessary to feedback the situation to the manufacturer, because the piston and the trunnion cylinder, the guide rail and the piston rod have relative movement, if the lubrication is poor or the trunnion cylinder bore is abnormal, it will aggravate the wear and reduce the straightness of the trunnion cylinder center line. In this way, when the piston works in the trunnion cylinder, the friction resistance will be large and small, resulting in slip or crawling. The solution is to repair and grind the trunnion cylinder first, and then prepare the piston according to the matching requirements, repair and grind the piston rod, and configure the guide sleeve.

Answers to some questions about trunnion cylinder:

Why does the cylinder pop out of itself when it stops?
This situation has two possibilities, 1. There is more air in the system, so exhaust the gas. 2. The back pressure of the oil return is relatively large, check the oil return filter, check whether the cylinder has a rod cavity buffer is too tight, and choose a 3-position 4-way M-type valve for the reversing valve. In addition, after the shutdown, manually change the reversing valve back and forth several times, it should not rise out.

How big is the motor and oil pump for the 80 cylinder?
Pump motor selection is not only related to cylinder diameter but also speed system, it is recommended to provide system diagram and speed requirements, generally speaking, most of the 80 cylinder on the market is equipped with 3-4KW motor, 10-20 oil pump.