servo cylinder Sold to Panama

This article mainly introduces:

Panama hydraulic cylinder,servo cylinder manufacturer,servo cylinder

(Panama servo cylinder,produced by Hengyu Group）

servo cylinder are widely used in Panama，because of excellent temperature resistance，no transmission clearance，powerful torque.So our company has designed servo cylinder for customers from Panama.

Introduction to servo cylinder:

servo cylinder installation precautions: Before installing the servo cylinder into the system, the parameters on the servo cylinder label should be compared with the parameters when ordering. The base of the servo cylinder must have sufficient stiffness, otherwise the servo cylinder will bend upward into a bow when pressurized, so that the piston rod will bend.

In order to ensure the service life of the servo cylinder, the hydraulic system must be set up effective filtration to prevent pollution, the cleanliness of the oil should meet the ISO4406 standard, and the quality of the filtration should also meet the corresponding standards in ISO. The grade requirements of the filter are performed according to the actual working conditions of the system, but the minimum requirements are not less than 19/15 in ISO4406, that is, 24μ (β10≥75) in ISO4572.

Do not regularly check the damage of the chrome layer of the servo cylinder: completely extend the servo cylinder and carefully check whether there is any surface damage such as injury, strain, welding slag, such as the surface damage position, in the servo cylinder block < 20cm, and the damage depth < 5mm, should be repaired in time to prevent long-term damage to the servo cylinder seal. Welding slag is strictly prohibited on the surface of the servo cylinder.

When installing the servo cylinder, the axial ends of the servo cylinder cannot be fixed. Due to the effect of liquid pressure and thermal expansion in the servo cylinder, there is axial expansion. If the two ends of the servo cylinder are fixed, all parts of the servo cylinder will be deformed. When disassembling the servo cylinder, it is strictly forbidden to hammer the servo cylinder and the piston surface, such as the servo cylinder hole and the piston surface is damaged, do not allow sandpaper grinding, to use a fine oil stone carefully grinding. The clearance between the guide sleeve and the piston rod should meet the requirements.

Answers to some questions about servo cylinder:

Where is the cylinder used? What is it used for? Can it be used in cars?
Cylinders can be used as actuator in hydraulic system. Such as hydraulic jacks, dump truck box lifting device, dodging (snow) machine loader bucket lifting device. Hydraulic cylinders are also widely used in car cranes. It's all about cars.

Why does excavator cylinder oil leak?
Under normal circumstances, the leakage of hydraulic cylinders is divided into internal leakage and external leakage. The external leakage is generally due to damage to the oil seal at the extended end of the piston rod and needs to be replaced. Internal leakage is generally because the oil seal on the piston is damaged, you can try to replace the oil seal here, if the replacement will also leak, then check whether there is damage to the inner wall of the cylinder.