trailer hydraulic cylinder Sold to Libya

This article mainly introduces:

Libya hydraulic cylinder,trailer hydraulic cylinder manufacturer,trailer hydraulic cylinder

(Libya trailer hydraulic cylinder,produced by Hengyu Hydraulic Co., Ltd）

trailer hydraulic cylinder are widely used in Libya，because of high work efficiency，excellent fatigue and impact resistance，smooth movement.So our company has designed trailer hydraulic cylinder for customers from Libya.

Introduction to trailer hydraulic cylinder:

The repair method of trailer hydraulic cylinder wear: 1. Metal repair material is applied to the scratched surface; The first layer should be thin, uniform and fully covered with the scratched surface to ensure the best adhesion between the material and the metal surface, and then apply the material to the entire repair site and press repeatedly to ensure that the material is filled and reaches the required thickness, so that it is slightly higher than the surface of the guide rail; 2, the material at 24℃ to fully achieve the performance of 24 hours, in order to save time, can be through the tungsten halogen lamp to increase the temperature, the temperature rises 11℃, the curing time will be reduced by half, the best curing temperature 70℃; 3. After the material is cured, use a fine grinding stone or a scraper to repair and smooth the material higher than the surface of the guide rail, and the construction is completed.

After the trailer hydraulic cylinder is installed, lubricating grease should be added to the relative moving parts such as earring and middle hinge shaft before trial operation.

trailer hydraulic cylinder can not drive the load troubleshooting: oil pressure is too low. trailer hydraulic cylinder selection specifications are too small. Leakage in trailer hydraulic cylinder or associated hydraulic system element.

When the trailer hydraulic cylinder needs to be disassembled for maintenance due to leakage and other faults, the piston should be moved to the bottom position of the trailer hydraulic cylinder, and hard beating and sudden drop are strictly prohibited during disassembly.

Answers to some questions about trailer hydraulic cylinder:

Does the sealing string of the upper and lower chamber of the hydraulic cylinder fall by itself?
It is possible, the probability accounts for 85% (depending on the weight), the weight is less than the system resistance, may not fall, the weight is greater than the system resistance, will not necessarily fall, so often check the equipment, safety first, find the problem in time to solve, the cylinder is not very expensive parts, maintenance does not cost much money, However, accidents caused by cylinder failure will lose several times the cost.

How to remove the lifting cylinder from the forklift truck?
The lifting cylinder is generally fixed on the door frame, and there are screws under and above it, and it is OK to loosen the screws with a wrench on the top. However, we must pay attention to ensure safety and prevent damage to the cylinder or safety accidents.