metallurgical cylinder Sold to Jordan

This article mainly introduces:

Jordan hydraulic cylinder,metallurgical cylinder manufacturer,metallurgical cylinder

(Jordan metallurgical cylinder,produced by Hengyu Hydraulic Cylinder Factory）

metallurgical cylinder are widely used in Jordan，because of smooth movement，high work efficiency，excellent fatigue and impact resistance.So our company has designed metallurgical cylinder for customers from Jordan.

Introduction to metallurgical cylinder:

Factors that should be considered when selecting the oil seal in the metallurgical cylinder: some specific factors should be taken into account when selecting the oil seal in the metallurgical cylinder, so as to have correct consideration and get accurate results, and then avoid wrong selection. The factors and aspects that should be taken into account are eight: metallurgical cylinder diameter, piston rod diameter, piston rod and piston groove size, metallurgical cylinder working pressure, metallurgical cylinder movement speed, hydraulic system oil temperature and metallurgical cylinder working environment.

The metallurgical cylinder body is commonly made of No. 20, 35, 45 seamless steel pipe, and the steel pipe is honed or rolled to achieve the roughness requirement within 0.4μm. The low pressure metallurgical cylinder can use 20 steel pipe, and the high pressure metallurgical cylinder can use 45 steel pipe.

Piston metallurgical cylinder is widely used in hydraulic transmission. When the metallurgical cylinder works, it mainly delivers hydraulic oil alternately to both sides of the piston in the metallurgical cylinder, and uses the pressure difference of hydraulic oil on both sides of the piston to realize the reciprocating movement of the piston. If you want to speed up the forward speed of the piston, the return oil in the metallurgical cylinder can be controlled by the valve and directly input into the inlet pipe to participate in the work of the piston to achieve rapid movement of the piston, but the thrust of the piston is reduced much.

The meaning of the metallurgical cylinder model marked by the metallurgical cylinder manufacturer: for example, 160/100-1150, its meaning: from a professional point of view, 160 refers to the metallurgical cylinder diameter, which is 160mm, and the 100 behind refers to the rod diameter, which is 100mm. The 1150 refers to the metallurgical cylinder stroke, which is 1150mm. Therefore, on this point, we should have a correct understanding and can not make mistakes.

Answers to some questions about metallurgical cylinder:

How does the self-locking cylinder work?
Hydraulic cylinder self-locking is divided into oil self-locking and mechanical self-locking. The oil circuit itself is equipped with a valve to maintain pressure, so that the hydraulic oil of the cylinder does not return to the tank, and the oil chamber of the cylinder is filled with a certain pressure of oil. However, this pressure holding self-locking is not very safe and reliable, and the plunger will slowly return if there is a leak. Mechanical self-locking is to install a nut on the plunger of the cylinder, and when the cylinder rises to the required position, the nut on the cylinder plunger is rotated to the end, and the cylinder block is in contact, so that the plunger will be fixed to the required height. When it is necessary to relieve the pressure, screw the nut on again and let the plunger return to the position. This kind of cylinder has a special name, called self-locking hydraulic cylinder.

How to take out the diaphragm of hydraulic cylinder? The septum ring is also known as the septum sleeve, when the cylinder is too long, and does not need too much travel, add the septum sleeve, limit the stroke of the hydraulic cylinder, set on the piston rod, only contact with the guide sleeve and piston, do not cooperate with the cylinder, limit the stroke, take out the difficulty is different, need to have such a professional tool, before taking out to consult the manufacturer.